|
Stripping and Re-Coating: (Sometimes referred to as Stripping and waxing)
1. Stripping is the process of removing all floor finish
and/or sealer from the floor. It is the most aggressive step and is sometimes needed to start the floor care cycle if the
floors have not been properly maintained or if it has been some time since the floors have been stripped.
As with
most refurbishing jobs, proper preparation is everything. Once the floor has been stripped it may also need to be re-sealed.
It will also need at least three coats of new floor finish.
This process should only need to be performed once
a year or longer, as long as the other steps are being performed regularly or the floors have not been properly maintained.
2. Daily Maintenance:
Now that the floors have been stripped
and re-coated, it needs daily maintenance in order to keep the clean, glossy look. If daily maintenance is not performed regularly,
the finish will not hold up and the floor appearance will diminish quickly.
Daily maintenance includes sweeping (or
vacuuming) the floor and then mopping the floor with a neutral pH floor cleaner.
If you cannot afford to have the
floors maintained daily, then an employee should be assigned to do it until your cleaning service returns for their next service
date.
Burnishing or Spray Buffing:
When daily maintenance no longer restores the floor to the desired level of appearance, either burnishing
or spray buffing services are in order.
Burnishing and/or spray buffing will help to restore the clean look and
shine, and will also prolong the need for stripping and re-coating, which can be expensive.
Scrubbing and Re-Coating:
When burnishing
or spray buffing no longer restores the shine to the floor, you can remove a couple of coats of finish and re-apply new layers
of finish.
This will remove all embedded dirt, heel marks, and restore the floors to an almost freshly stripped
an re-coated condition. It is very similar to stripping and waxing, but there is no need to completely remove all the finish
from the floor.
This is an economical way to extend the life cycle, which means it will prolong the need for the
stripping and re-coating process.
When scrubbing and re-coating are no longer effective,
it is time to start the cycle all over again with stripping and re-coating. As mentioned earlier, most floors should only
need to be stripped and re-coated once a year or longer, as long as the other steps are being performed regularly.
|
